Preset setting: adjust the camera to the appointed angle and location using directional buttons, and then select a preset number from the
preset drop-down list; click
list, then click
Cruise: 0-255 presets can be added; stay time 1-255s (adjustable), cruise speed 1-7 levels (selectable). All cruise tracking can be recalled
and deleted independently. Clear cruise: click
scan which has been set.
Track setting: select a number from the tracking drop-down list, click
click
Linear Scan: select a number from the linear drop-down list, click
serious PTZ operation, then click
scanning, and the vertical angle depends on the final position; the linear path is a two-point minimum. path. Recall linear:
select a number from the linear drop-down list and click
Idle op.: Idle op. includes None, preset setting, cruise scan, tracking, linear scan. Click
1-15 min. (selectable); click
been completed. When idle op. has been set successfully, the speed dome camera will carry out an idle op. procedure after
the set idle time has elapsed.
IR light: Auto/Manual can be selected; when Auto is selected, it will turn on the IR LED according to the zoom module
multiples. When Manual is selected, there are four options: All closed/near open/middle open/far open.
Privacy Mask: select a number from the Mask drop-down list, click
save and exit mask setting.
3D Position: the 3D position function can be open or closed.
Show Smart Detection Rule: choose whether to display smart detection types (four types in total: Target Count, Object Left/Lost,
Area Detection, Line Crossing).
Show Smart Detection Result: choose whether to display the smart detection statistical result.
Rev. A
to confirm. Call preset: select the preset number you want to call from the preset drop-down
to call it.
to save and exit the tracking path setting. Call tracking path: select a number from the tracking drop-down list and
to recall the tracking path.
to clear all cruise scan settings, Call cruise:
to save and exit the linear scan setting. Linear scan only supports horizontal
to recall linear scan.
to save the idle op. setting and click
Figure 3-8
Figure 3-9
click
, and carry out a serious PTZ operation, then click
to set the linear scan initial position, and carry out a
to set idle op., with an idle time of
to check whether the idle op. setting has
to set the masking area, then click
to recall the cruise
to