1 Menu settings
After the machine is installed and powered on, the PTZ camera will be self-checked, and
the screen will display boot information, as shown in Figure 1-0-0.
Address
Communication protocol
Baud rate
F i g u r e 1 - 0 - 0
Explanation: When the PTZ camera is set up differently, the specific values of each item
will also be different. This prompt will disappear until the PTZ camera has completed self-
examination. Note: Only when the system display function is turned on in the menu, will
display the boot information.
Enter the main menu: Set the 95 preset point first and then calling the 95 preset point.
At this time, the screen shows the main menu, as shown in Figure 1-0-1.
Main menu
System information
PTZ settings
Camera settings
Permissions settings
System settings
Exit
F i g u r e 1 -0-1
1.1 System information
In the menu of Figure 5-0-1, move the rocker up and down so that the cursor points to the
system information, and then move the rocker to the right to display the system information,
as shown in Figure 5-1-1.
Address
Communication protocol
Baud rate
Software version
Figure 5-1-1
Description: The arbitrary movement of the rocker to exit system information display.
Display PTZ camera address
255
Display protocol recognition method
PELCOD
9600
Display baud rate recognition method
Display system information→ (F i g u r e 1-1-1)
PTZ settings → (F i g u r e 1-2-1)
Camera settings → (F i g u r e 1-3-1)
Permissions settings→ (F i g u r e 1-4-1)
System settings → (F i g u r e 1-5-1)
255
PELCO-D
2400
V1.10
Display PTZ camera address
Display communication protocol
Display communication baud rate
Display software version
7