Line Crossing - Comelit PPTZ120IRE Manuel Utilisateur

Line Crossing

Network High Speed Dome "Line Crossing" setting interface as shown in the figure below.

Enable: enable or disable the virtual guard function.

Arming Schedule: the arming schedule can be set from Monday to Sunday.

Area Setting: in the "Area Setting" preview interface, click "drawing", click the left mouse button to set the warning line, then right-
click to complete; the target will trigger the alarm when going through the line.

Clear: click Clear to delete all the detection areas.

Swap AB: click "swap AB" to exchange positions between A and B.

Detect Area: to add a new guard line (max. 4 guard lines supported), the parameter setting can be set for the corresponding guard
lines option.
 Detect Type: set the guard lines to trigger the alarm. A→B refers to the targets passing through the guard line from area A to area
B and triggering the alarm. A←→B refers to the targets passing through the guard line from area A to area B or from area B to
area A; both will trigger the alarm.

Object Percent: set the min. area percentage for the object; if the area of the target passing through the guard line is smaller than
the set value, it will be invalid and the alarm will not be triggered.

Email: click Email. Once the alarm triggers it will send an email to the appointed mailbox.

Snap: click Snap. Once the alarm triggers the linked camera will take a snapshot picture and store it on the Micro-SD card.

Record: click Record. Once the alarm triggers the linked camera will record a video and store it on the Micro-SD card.

Alarm Output: there is an active warning device connected to the alarm output port. Once the alarm triggers it will cause the linked
embedded relay switch to execute an alarm output.

PTZ: enable or disable PTZ function.

Preset: when virtual guard triggers the alarm, it will link the presets.

Snap Interval: set the snapshot interval time.

Snap Number: set the snapshot image count for every time.
After all parameter settings have been completed, click "Save" and they will come into effect immediately.
Rev. A
Figure 3-28