Connect related cables according to actual need (Power line, network line, audio line, etc.)
Connect the power supply
Please read the Note carefully; if you have any questions please contact us without hesitation.
Note:
When opening the box, please check all parts carefully and confirm the parts in the box are the same as on the packing list.
Please read the user manual carefully before installation.
Make sure all power is turned off when installing the camera.
Please confirm the power transformer to avoid damaging the device with an unmatched power source.
Network connection
LAN connection
Use one network line to connect the IP camera to a concentrator or switchboard for the LAN. As shown below, you can also use one
network line to connect the Network High Speed Dome directly to your network card or switchboard.
WAN connection
Use one network line to connect the Network High Speed Dome to a Router or XDSL Modem/Cable Modem (shown below).
Connect the power supply
After connecting the power source, the network camera will start up automatically.
Rev. A
Figure 2-3
Figure 2-4
Loosen the back cover
screws (4pcs) and take off
the cover
Insert micro-SD card