Comelit PPTZ120IRE Manuel Utilisateur page 50

Fixed IP mode
See below picture for the network topology:
Please refer to the below picture for the network settings:
Setting steps:
1. Log in to the Network High Speed Dome via crossover cable direct connection (for details, please refer to "Hardware
Installation").
2. Switch to the network settings; fill in the device IP address requested from the network service provider in Basic Parameters,
such as 218.84.31.168.
3. Enter the correct subnet mask, e.g. 255.255.255.0.
4. Enter the correct gateway address, e.g. 218.84.31.131.
After setup completes, click Save and restart the device, then connect it to public network so that all Internet users can view the Network
High Speed Dome remotely via
Broadband and router sharing Internet access mode (dynamic obtainment of extranet IP address mode) such as ADSL and so on.
If you select router dial-up to connect to the internet, see below picture for the network topology:
Users can set up the DDNS domain name service at the same time. Enter the username and password applied for the DDNS server to the
DDNS setting item and implement port mapping from the router. The router determines and points to the Network High Speed Dome that
needs to be viewed according to different ports; long-distance Internet users can view the Network High Speed Dome on the network directly
via domain name.
Please refer to the below picture for the network settings:
Rev. A
http://218.84.31.168 on IE browser.