HYDAC ELECTRONIC ETS 3000 Série Notice D'utilisation page 39

ETS 3000 IO-Link
Designation
Unit conversion
Unit °C
Unit °F
Max. value
Min. value
Error indication
Reset
Yes
No
Reset min/max value
Programming lock
Version
Note:
• If the actual temperature exceeds the unit's rated temperature, or if it ranges
below the bottom temperature value, it can no longer be displayed. The rated
value or the bottom temperature value will start to flash in the display. As a result,
when the menu point "max value" (Hi) is selected, the value of the highest
measured temperature (respectively the lowest measured temperature) which
has been stored flashes, until the command "RS.HL" for "reset min/max value" or
"rES" for "reset", is carried out.
Edition: 2015-04-14
Representation on
7-segment display
uni
e
F
ki
lo
ERR
---
Yes
No
rS. k L
Pr6
Uer
HYDAC ELECTRONIC GMBH
9
ASCII
representation
Uni
°C
°F
HI
LO
ERR
---
Yes
No
rS.HL
PrG
Ver
Part No.: 669904