Installation And Removal Of The Rotor - Hettich ROTANTA 460 Robotic Mode D'emploi

13

Installation and removal of the rotor

• Clean the motor shaft (C) and the rotor drilling (A), and lightly grease the motor shaft
afterwards. Dirt particles between the motor shaft and the rotor hinder a perfect seating
A
of the rotor and cause an irregular operation.
•
Place the rotor vertically on the motor shaft. The motor shaft dog (D) must be in the
rotor slot (B) and the white marking (E) on the dog (D) must be on the side of rotor
B
position 1. The alignment of the groove is labelled on the rotor.
C
E
D
• Tighten the rotor tension nut with the supplied wrench by turning in a clockwise
direction.
• Check the rotor for firm seating.
•
Loosening the rotor: Loosen the tension nut by turning in a counter clockwise direction,
and turning until the working point for lifting. After passing the working point for lifting
the rotor is loosened from the motor shaft cone. Turn the tension nut until the rotor is
able to be lifted from the motor shaft.
AB5680DEENFRIT
E
Rotor position 1 is already adjusted ex works. Rotor position 1 is the position
where place 1 of the rotor must be located for loading and unloading.
The white marking (E) on the dog (D) must be on the side of rotor position 1 so
that the position of rotor position 1 and the adjusted rotor position 1 agree. To
adjust rotor position 1, see the chapter "Setting rotor position 1".
Rev. 12 / 04.2020
E
EN
65/179