Draining And Cleaning The Tank; Application - Solo 450 Manuel D'utilisation

value be too low, sediments inside the metering
body may be the cause. Clean the corresponding
parts and repeat the checking procedure.
Should the actual value be too high, the metering
body may be worn or damaged. In that case, replace
the metering body with a new one (part no.:40 74
165).
When using accessory sets (liquid pump part no.: 44
00 235 or ULV accessory, part no.: 49 00 479) a
strainer will be integrated into the tank connector.
In that case, an incorrect flow rate can also be due
to a contaminated or worn strainer.
Clean or replace the contaminated/worn strainer
(part no.: 25 00 198).

6.7 Draining and cleaning the tank

For cleaning purposes, the tank can be fully drained
into a suitable container via the supply hose.
For this, the engine must be cooled down.
osition the equipment onto a stable higher support,
so that the spray medium can drain into a suitable
container below.
Fig. 12
Above the container, pull the supply hose from the
shut-off valve.
If required, tip the equipment slightly to drain the
tank completely.
Ensure that the spray medium does not run over the
equipment (especially the engine), but drains
directly into the suitable container.
Dispose of residual spray medium correctly at
disposal sites licensed for specialised waste.
Empty the spray medium tank daily after work and
flush thoroughly with water.
Observe cleaning instructions supplied with the
herbicide/fungicide.
After cleaning, let the spray medium container dry
in an open state.
Fig. 13
Occasionally clean the strainer inside the filler neck,
the strainer in the accessory set and all parts in
contact with the medium, with water and a soft
brush.

6.8 Application

According to its type designation, this equipment is
suitable for:
Agriculture,
horticulture,
orchards,
green spaces,
vineyards,
nurseries;
Operating Hints
ENGLISH 13