Starting / Stopping The Engine - Solo 450 Manuel D'utilisation

Starting / Stopping the engine

5. Starting / Stopping the engine
Starting with cold engine
Fig. 5
Switch ignition switch to "I" position and close
(OFF) formula on/off tap .
Move throttle lock lever to "Start" position.
Fig. 6
Close choke with choke lever.
Press primer several times until fuel is visible in
the primer.
Das Gerät mit der linken Hand am Tank
abstützen. Mit der rechten Hand den
Place your left hand on the formula tank of the
mistblower. Hold the starter handle (Fig. 1.Pos. 7)
with your right hand and pull the handle up
ENGLISH 10
slowly until resistance is felt. Then pull up firmly
and rapidly until the engine 'fires'.
Once the engine tries to start, immediately open
the choke and continue to start.
When the engine runs, use the throttle lever to
accelerate to the required engine speed. For
continuous use, set the throttle lock lever (Fig. 1,
Pos. 18) in the required position for the desired
engine speed.
To return to idling speed, either release the
throttle lever or move throttle lock lever down to
"min" position.
Starting with warm engine after short stop
Leave choke in "open" position
engine.
Should the engine refuse to start despite several
starting attempts, the combustion chamber is most
likely flooded.
In this case we recommend you remove and dry the
spark plug (Fig.1,4). Set the ignition switch to "stop"
and set throttle lock lever (Fig. 1, 18) to full throttle
position "max". Pull over engine several times, still
with spark plug removed. This will ventilate the
combustion chamber
Replace spark plug and repeat starting procedure.
Shutting off engine
Release throttle lever and move throttle lock lever
to "min" position.
Move ignition switch to "Stop" position until
engine stops.
and start