Parts Subject To Wear And Tear - Solo 471 Instructions D'emploi

Masquer les pouces Voir aussi pour 471:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Preface
Dear Customer,
We congratulate you on your new SOLO Blower
Unit and hope that you will be satisfied with this
modern tool.
A state-of-the-art single cylinder two-cycle
engine with Nikasil coated cylinder bore combined
with renowned SOLO technology of high
performance with low fuel consumption will
guarantee a high degree of application value of this
product.
Read this operating manual carefully before
using the machine for the first time and at all times,
strictly observe all safety rules.
In order to maintain the longterm performance
of the SOLO Blower it is necessary that the
maintenance instructions be followed.
Should you require any further information
after carefully studying this manual, please contact
your specialist SOLO Dealer.
CE Declaration of conformity
In accordance with CE directives 98/37 EC, 2000/14/EG and
89/336/EWG (amended with 92/31/EWG),
SOLO Kleinmotoren GmbH, Stuttgarter Strasse 41,
D-71069 Sindelfingen, being solely responsible, states that
the product referred to in this declaration complies with
the requirements of the machinery guidelines.
Sound power level (DIN45635)
Guaranteed sound
Actual sound
This declaration of conformity loses its validity, if the
equipment is converted or modified without the
manufacturer's consent.
Sindelfingen,
1
January 2005
st
SOLO Kleinmotoren GmbH
ENGLISH
2
471
472
96,5
101,5
dB(A)
96,0
101,0
dB(A)
Wolfgang Emmerich
Geschäftsführer
Symbols
The following symbols are used in this manual and
on the product:
Thoroughly read these operating
instructions before undertaking any
maintenance, installation and cleaning
steps
Always handle this power tool with
particular care
Prohibited
Wear eye and ear protection
Do not smoke
No open flame
Starting of engine
Switch off engine
Wear protective gloves
fuel mixture
choke open
choke closed

Parts subject to wear and tear

Various parts are subject to application-specific or
normal wear and must be replaced in good time,
when required. The following parts are subject to
normal wear and are not covered by the
manufacturer's guarantee:
Air filter
Fuel filter
All rubber parts which come into contact with
fuel
Spark plug
Starter

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

472

Table des Matières