Assembly; Assembly Of Misting Equipment; Assembly Of Handle, Spray Tube And Spray Nozzle - Solo 450 Manuel D'utilisation

Assembly

4. Assembly
Fig. 4
Completely assembly the mistblower before its first use::

4.1 Assembly of misting equipment

Attach the blower elbow (1) to the blower housing and secure with both screws (Fig.4D; A+B). Ensure the elbow
can swivel easily. Push pleated hose onto blower elbow and secure with clamp (4).

4.2 Assembly of handle, spray tube and spray nozzle

Push handle (5) onto spray tube (start from the front) and fix in the required position (Fig.4C). A guide (7) on the
spray tube will ensure vertical positioning.
Push the spray tube with twist coupling (11) into the pleated hose (5) until locked. Secure with clamp (8).
Note: The spray tube can be twisted and turned in the pleated hose with the handle. Ensure that all hose and
cable connections are safe and without sharp bends.
Place spray nozzle (9) on to spray tube (vertical to handle) and secure (10).
Push formula delivery hose (2 pieces) on nipple of the handle and to the spray nozzle. Secure the hose alongside
the pleated hose. Shut on/off tap (vertical position), fill some plain water in formula tank and check for any
leakage.
ENGLISH 9