Starting / Stopping The Engine - Solo 471 Instructions D'emploi

Starting / Stopping the engine

5. Starting / Stopping the engine
Starting with cold engine
Fig. 6
Switch ignition switch (6.1) to "I" position and
close (OFF) formula on/off tap .
Move throttle lock lever (6.3) to "Start" position.
Fig. 7
Close choke with choke lever.
Press primer several times until fuel is visible in
the primer.
Hold the machine with your left hand on the
carrying handle (1.15). With the right hand,
slowly pull out the starter handle (1.8) until
resistance is felt. Then pull quickly and forcibly
until the engine attempts to start (engine fires).
Once the engine tries to start, immediately open
the choke and continue to start.
ENGLISH 10
When the engine runs, use the throttle lever (6.2)
to accelerate to the required engine speed. For
continuous use, set the throttle lock lever (6.3) in
the required position for the desired engine
speed.
To return to idling speed, either release the
throttle lever or move throttle lock lever down to
"min" position.
Starting with warm engine after short stop
Leave choke in "open" position
engine.
Should the engine refuse to start despite several
starting attempts, the combustion chamber is most
likely flooded.
In this case we recommend you remove and dry the
spark plug (1.9). Set the ignition switch to "stop"
and set throttle lock lever (6.3) to full throttle
position "max". Pull over engine several times, still
with spark plug removed. This will ventilate the
combustion chamber
Replace spark plug and repeat starting procedure.
Shutting off engine
Release throttle lever and move throttle lock lever
to "min" position.
Move ignition switch to "Stop" position until
engine stops.
and start