Steca Elektronik coolcept Notice D'installation Et D'utilisation page 94

GB
3.6.1 Data
The inverter can transmit a wide range of data to other devices. Some of this data is shown on the
display and certain data is stored in the internal memory (EEPROM) as described below.
Displayed data
Voltage and current of the solar generator
n
Power and current fed into the grid
n
Voltage and frequency of the power grid
n
Energy yields on a daily, monthly and annual basis
n
Error conditions, notes
n
Logged data (EEPROM)
Event messages with date
n
Energy yields on a daily, monthly and annual basis
n
The storage resolution of the energy yield data is as follows:
Energy yield data
10-minute values
Daily values
Monthly values
Annual values
Total yield
3.6.2 Network (TCP/IP)
The device can transfer yield data and event messages via the TCP/IP interface to the Internet portal
http://www.solare-energiewende.de . The yield data can be displayed graphically in the
server at
Internet portal as illustrated below. This service is free of charge for 2 years. The following applies:
The user must first register at
n
The local network settings must be set at the inverter in order to establish a connection to the
n
Internet portal server. This can be performed automatically or manually:
Automatically:: If IP addresses are automatically assigned in your network (DHCP), then no set-
tings need to be made at the inverter.
Manually: If IP addresses are not automatically assigned in your network, then you must man-
ually set the inverter network settings via Settings ▶ Network; see
The address of the Internet portal server is permanently stored in the inverter and cannot be
n
changed.
Once the network connection is established, the inverter automatically starts non-encrypted
n
transmission of data to the server.
94
Storage resolution/period
31 days
13 months
30 years
30 years
Permanent
www.steca.com/portal before the Internet portal can be used.
Ä , p. 89
747.431