Steca Elektronik coolcept Notice D'installation Et D'utilisation page 88

GB
3.3.3 Settings
Numerical settings
Selection of the measurements
88
① Designation of the numerical setting
② Value to be set; the selected value to be set is highlighted in
black.
When performing numerical settings of remuneration and dates,
the following applies:
Remuneration
Possible currencies: £ (Pounds), € (Euros), kr (Krones),
n
The maximum value that can be set for remuneration is
n
limited for technical reasons. The remuneration must be set
using different units as required. Example: Dollars instead of
Cents (set a currency of
Date
When setting the month/year, a check is performed to ensure that
the selected day is valid. If not, then the day is automatically cor-
rected.
Example: 31.02.2011 is corrected to 28.02.2011.
Selection of the measurements to be shown in the status display.
The following measurements can be selected:
Output power: output power of the inverter
n
Current day yield: day yield since 0:00
n
PV voltage: the voltage supplied by the solar modules
n
PV current: the current supplied by the solar modules
n
Grid voltage 1)
n
Grid current: the current fed into the mains grid
n
n Grid frequency
Internal temp.: the internal temperature of the inverter
n
Derating: cause for derating
n
Max. daily power: the maximum power supplied in the current
n
day 3)
Abs. max. power: the maximum power ever fed into the grid
n
Max. daily yield: the maximum daily yield achieved
n
Operating hours: The operating hours during which the device
n
has been connected to the grid (including nighttime hours).
Total yield: yield since commissioning
n
saving: CO
n CO
2 2
Measurement is always displayed (cannot be switched off)
1)
none ).
2)
savings achieved since commissioning
none .
1)
3)
3)
747.431