Steca Elektronik coolcept Notice D'installation Et D'utilisation page 85

3.3.2 Information
The information shown on the display is described below using illustrative examples.
Status display
The status display shows the following values:
1
3 4 5
9
747.431
①
Measurement name
②
Measurement with units
2 2
③
Date
F
④
Symbol
6 7 8
on this is provided in Section
⑤
Animated
indicates data traffic on the RS485 bus.
⑥
Symbol
⑦
Symbol
⑧
Time
⑨
IP address of the device when a network connection has
been established, display alternates with ③ – ⑦
The following applies to the status display:
The measurements shown in the status display are defined
n
under Settings ▶ Meas. values. Some measurements are
always displayed (default setting).
Current values are not displayed at night (solar irradiation too
n
low; example in Fig. left).
The CO2 saving shown in the status display are calculated
n
using the savings factor
Non-confirmed event messages ; more information
Connect symbol with 2‑digit inverter address;
Derating
Fixed voltage mode activated
508 g/kWh .
Ä 7, p. 119 .
GB
85