General Information; General Safety Instructions - Steca Elektronik coolcept Notice D'installation Et D'utilisation

GB
2

General information

2.1

General safety instructions

This document is part of the product.
n
Install and use the device only after reading and understanding this document.
n
Always perform the measures described in this document in the sequence specified.
n
Keep this document in a safe place for the entire service life of the device. Pass the document
n
on to subsequent owners and operators of the device.
Improper operation can reduce the yields of the photovoltaic system.
n
The device must not be connected to the DC or AC cables if it has a damaged casing.
n
If one of the following components is damaged, immediately take the device out of operation
n
and disconnect it from the mains grid and solar modules.
– Device (not functioning, visible damage, smoke, etc.)
– Cables
– Solar modules
The system must not be switched on again until:
– The device has been repaired by a dealer or the manufacturer.
– Damaged cables or solar modules have been repaired by a technical specialist.
Never cover the cooling fins.
n
Do not open the casing. Risk of death. Invalidation of the guarantee.
n
Factory labels and markings must never be altered, removed or rendered unreadable.
n
Observe the respective manufacturer's manual when connecting an external device that is not
n
described in this document (e.g. external data logger). Incorrectly connected devices can
damage the inverter.
Safety instructions on the device
2
Attention
Présence de deux sources
Isoler les deux sources
de tension
- Réseau de distribution
- Panneaux photovoltaïques
10min
1
S/N: 746867XG001155550005
76
① Dangerous voltages can remain present on the compo-
nents up to 10 minutes after switching off the DC circuit
breaker and the line circuit breaker.
3
② Warning. There are 2 voltage sources present: power
grid, solar modules.
avant toute
③ Disconnect both voltage sources from the device before
intervention
working on the device: the solar modules via the DC cir-
cuit breaker and the power grid via the line circuit
breaker.
4
④ Read and follow the instructions!
⑤ Serial number as a barcode and in plain text
5
747.431