Steca Elektronik coolcept Notice D'installation Et D'utilisation page 134

GB
Disconnection values are upper and lower deviations from the average values of the rated
3)
voltage (in %) and the associated switch-off time (in s).
Disconnection values are upper and lower deviations from the rated frequency (in Hz) and the
4)
associated switch-off time (in s).
StecaGrid 3600 and 4200 only:
5)
Maximum output power Belgium 1 / Belgium 2: 3330 W
Maximum output power Belgium 1 unl. / Belgium 2 unl.: 3600 W
The rated voltage is 240 V (instead of 230 V).
6)
All units except the StecaGrid 1800: maximum output power 2000 W
7)
The rated voltage is 220 V (instead of 230 V).
8)
————————————————————————————————————————
9)
ATTENTION
Danger of yield losses. Activation of the
the public power grid.
————————————————————————————————————————
Activation of the
with a stand-alone inverter in a system that is not connected to the public power grid.
The requirements for the country-specific grid parameters may change at short notice. Contact
the Steca Customer Service if the parameters specified in the table below no longer correspond
to the legally prescribed requirements in your country. See Ä Contact, p. 137.
Information on setting the country are provided in Ä 4.7, p. 106 et seqq.
134
Droop Mode is recommended when the inverter is operated in conjunction
Droop Mode is not permitted in systems connected to
747.431