Steca Elektronik coolcept Notice D'installation Et D'utilisation page 110

GB
n
Node
Display characteristic curve
Finish
110
1. Press rs to select a parameter for the node.
———————————————————————————
Notice
P % cannot be changed at the first and last nodes (000 %,
100 %).
———————————————————————————
2. Press SET. The parameter value flashes.
3. Press rs to change the value.
4. Press SET. The change is adopted.
5. Repeat steps 1 to 4 for the other parameters.
6. Press ESC. The check list is shown.
1. The previously set reactive power characteristic curve is dis-
played graphically (example in Fig. left).
2. Press ESC. The check list is shown.
✔ Finish has been selected in the check list and SET has been
pressed. One of 2 possible dialogues is displayed.
1. Proceed as follows, depending on the respective dialogue:
Dialogue Settings are incomplete: Press SET and and
n
work through the open items in the check list.
Dialogue Are all settings correct?:
n
Press ESC to correct settings or
Press and hold SET (> 1 s) to finish initial commis-
sioning.
2. If SET was pressed for a longer time then the inverter starts
anew and synchronises itself with the grid (Fig. left).
747.431