Steca Elektronik coolcept Notice D'installation Et D'utilisation page 112

GB
Disconnecting the AC plug from the inverter
Opening the AC plug (only if required)
Removing the inverter from the mounting surface
112
1. Remove the AC plug from the socket on the inverter as
described in the Appendix under Mounting ⇒ AC plugs.
2. Check that all pins of the AC plug are free of voltage. Use a
suitable voltmeter for this (do not use a simple neon phase
checker).
u Open the AC plug as described in the Appendix under
Mounting ⇒ AC plugs.
1. Use one hand to press the retaining plate on the mounting
plate approx. 5 mm towards the mounting surface ① (Fig.
left).
2. Use the other hand to push the inverter upwards, far enough
so that the retaining plate no longer latches ②. Release the
retaining plate.
3. Lift the inverter with both hands until the hooks on the rear
side of the inverter are free ③.
4. Remove the inverter from the mounting surface ④.
747.431