Adjusting The Rear Shock Absorbers; Adjusting The Handlebar - Malaguti Spider Max GT500 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5.9 ADJUSTING THE REAR SHOCK ABSORBERS

The shock absorbers are equipped with a spring preload ring
nut, with which it is possible to adjust the vehicle's behaviour
depending on the load carried, how the vehicle is driven and
where.
The adjustment is carried out using the wrench supplied, by
acting on the ring nut located in the bottom section of the shock
absorbers (Fig. 34); turn it clockwise to increase the spring
preload.
If an excessive resistance is encountered, combine the shock
absorber wrench with the wrenching pipe supplied.
There are four adjustment positions:
1) Position one: driver only
2) Position two: drive and luggage case
3) Position three: driver and passenger
4) Position four: driver, passenger and luggage case.
adjust both shock absorbers according to the same
adjustment index. An unbalanced adjustment may com-
promise the vehicle's stability.
While riding with a passenger, preload the shock ab-
sorber spring at position '3'.
When adjusting, wear gloves to protect yourself against
scratching.

5.10 ADJUSTING THE HANDLEBAR

This vehicle features a handlebar that can be adjusted to suit
the driver's requirements (Fig. 35).
Have this operation performed by an Authorised
MALAGUTI Service Centre.
Fig. 34
ENGLISH
1
2
3
4
5
6
Fig. 35
41

Publicité

Table des Matières
loading

Table des Matières