Operating Instructions; Engine Break-In; Checks Before Use - Malaguti Spider Max GT500 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4

OPERATING INSTRUCTIONS

SUGGESTIONS
The condition of a vehicle is the owner's responsibility. Vital
functions of the vehicle can start to deteriorate quickly and
unexpectedly, even if the vehicle remains unused (for instance,
as a result of exposure to the elements). Any damage, fluid leakage
or loss of tire air pressure could have serious consequences.
Therefore, check all main vehicle components with great care
before use.
WARNING!
AFTER A LONG RIDE AT HIGH RPM, WHEN YOU
STOP THE VEHICLE
DO NOT TURN THE ENGINE OFF IMMEDIATELY
BUT LET IT RUN IDLE FOR ABOUT 30 SECONDS.

4.1 ENGINE BREAK-IN

Good running in is essential to ensure that the life of engine,
transmission and moving parts is sufficiently long.
During the first 1000 km (625 miles):
Avoid using full throttle and maintaining a constant speed for a
long time.
Do not use the vehicle over 80% of the top speed.
After the first 1000 km, increase speed progressively, as
established by the limits envisaged by rules in force.
Both during and after running in, use only UNLEADED
PETROL.

4.2 CHECKS BEFORE USE

PART
Fuel
Transmission and
engine oil
Tires
Nuts/screws/bolts
Steering
Front/Rear brakes
Throttle
Lights and indicators
Coolant
Stand
Loads
Checking takes a few minutes, but your safety and that
of other people is extremely important.
If you do not have time or prefer to make some closer
checks, apart from the essential maintenance checks
listed in section 5 of this manual, please contact an
Authorised MALAGUTI Service Centre.
ENGLISH
CHECK
Enough fuel.
Level within limits specified. Check for leaks.
Check pressure/wear/damage.
Check tightness.
Free movement from one end to the other.
Working properly and not worn; if
necessary, adjust or replace.
Operation should be smooth, if necessary
lubricate or adjust
Proper working conditions.
Presence of coolant or possible leakages.
Operation of stand and springs.
Make sure loads and accessories (e.g. rear
case) are firmly secured to vehicle.
1
2
3
4
5
6
25

Publicité

Table des Matières
loading

Table des Matières