Malaguti Spider Max GT500 Manuel D'utilisation Et D'entretien page 125

if there are several active alarm conditions, the display
will be showing them in the following order:
1 - Hydraulic stand alarm
2 - OIL LOW PRESSURE and ICE alarms
3 - OIL Check/Change e V. BELT Change Alarms
4 - LOW BATTERY alarm
If possible, the display will be showing all alarms in icon form.
The alarms will otherwise appear in sequence.
3.11.7 SET-UP MENU
Automatic Every time MODE Normal
display is pressed, display
contrast contrast is
setting increased by
1/8 of a notch
If MODE is not
pressed for 20",
Setup Menu is
closed
Fig.16c
Reversed Display Selection
display Menu is closed
and
Setup Menu
reappears (Fig. 16c)
Fig.16d
ENGLISH
With this menu, you can gain access to a series of functions for:
• setting the current time (TIME)
• setting the intensity of the backlighting (BACKLIGHT) (this func-
tion is available when the vehicle's lights are on)
• adjusting display contrast and mode (DISPLAY)
• informing the system that oil has been replaced (OIL). This func-
tion may only be used by staff of the Authorised MALAGUTI Serv-
ice Centre
• informing the system that the drive belt has been replaced
(V.BELT). This function may only be used by staff of the Author-
ised MALAGUTI Service Centre.
The Set-up menu can be opened only when the vehicle is station-
ary, by holding the MODE button down for about 2 seconds when
the TOD function is selected, until the Set-up display appears;
now press the MODE button again to scroll through the available
functions. Once you have selected the function you need, hold the
button down for about 2 seconds until you enter set-up mode.
Make your changes and confirm new settings by holding the
"MODE" button down until the previous menu reappears.
After setting, you can return to standard operating mode by hold-
ing the button down for at least 2 seconds after selecting the EXIT
function.
1
2
3
4
5
6
19