SOLIS BARISTA PRO 114 Mode D'emploi page 170

E
CARE AND CLEANING
CLEANING THE STEAM WAND AND FROTHING ATTACHMENT
Steam Wand
Maintenance
Remove attachement
• The steam wand and frothing attachment should
always be cleaned after frothing milk.
• Remove the frothing attachment and rinse in
warm tap water.
• Wipe the steam wand with a damp cloth, and
then with the steam wand directed back into
the drip tray, briefly set the steam dial to the
«STEAM» position. This will clear any remaining
milk from inside the steam wand.
170
Clogged
Steam Wand?
Run steam to clear
milk from wand after
frothing
• Ensure the steam dial is in the «STANDBY»
position. Press the POWER button to off and
allow the machine to cool.
• If the steam wand remains blocked, use the
pin on the cleaning tool to clear the opening.
• If the steam wand continues to be blocked,
the tip of the steam wand can be removed by
using the fitting in the middle of the cleaning
tool.
Clean hole with pin Remove tip
• Unscrew the top with the cleaning tool.
• Soak the tip in hot water before using the pin
on the cleaning tool to unblock. Replace the
tip back onto the steam wand and secure with
the cleaning tool.
Soak tip in hot
water