Error Codes - Migatronic OMEGA 270 MINI Manuel D'instruction

One of the below mentioned error codes will be displayed if an error occurs during software update.
Error codes for control software
10001501.xx.cry
Error code Cause and solution
There is no software present in the
control unit.

Insert a SD card with software in
the control unit and turn on the
machine.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT and place the files down
on the card or use another SD card.
SD card contains no software.

See page 15.
SD card has more files of the same
name.

See page 15.
The control unit has tried to read
more data than is accessible in the
memory.
1. Insert the SD card again.
2. Replace the SD card.
3. Contact MIGATRONIC Service.
Software on the SD card is locked for
another type of control unit.

Use a SD card with software that
matches your control unit.
Software on the SD card is locked for
another control unit with another
serial number/ bar code.

Use a SD card with software that
matches your control unit.
The internal copy protection does
not allow access to the
microprocessor.
1. Insert the SD card in the machine
again.
2. Contact MIGATRONIC Service.
The memory circuit is defective in
the control unit.

Contact MIGATRONIC Service.
The memory circuit is defective in
the control unit.

Contact MIGATRONIC Service.
The file 100015xx.xx.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.

ERROR CODES

Error codes for welding program package
10646001.xx.bin
Error code
18
Cause and solution
There is no welding programs
present in the control unit

Insert a SD card with software in
the control unit and turn on the
machine. See page 15.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT or use another SD card.
It is only possible to have one file
with welding programs.

Make sure that there is only one file
with the number 106460xx-xx.bin
on the SD card. See page 15.
The welding program package does
not match this control unit.

Use a SD card with software that
matches your control unit.
The welding program package is
locked for another control unit with
another serial number/ bar code.

Your software package is copy
protected and cannot be used for a
control unit without the correct
license.
The control unit is defective

Contact MIGATRONIC Service.
The file 106460xx.xx.bin is not
present on the SD card.

See page 15.
The file 106460xx.xx.bin has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
The Omega folder with files are not
present at the card or are saved
incorrectly.
1. Make a folder
MIGA_SW / OMEGA as described
on page 15 and save the files in the
folder.
2. Exchange the SD card