Error Codes - Migatronic FLEX 2 3000 Compact Manuel D'instruction

One of the following mentioned error codes will be displayed if an error occurs during software update.
Error codes for MWF software 10001341.cry
Error code Cause and solution
There is no software present in the
control unit.

Insert a SD card with software in the
control unit and turn on the machine.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT and place the files down on
the card or use another SD card.
SD card contains no software.

See page 19.
SD card has more files of the same
name.

See page 19.
The control unit has tried to read more
data than is accessible in the memory.
1. Insert the SD card again.
2. Replace the SD card.
3. Contact MIGATRONIC Service.
Software on the SD card is locked for
another type of control unit.

Use a SD card with software that
matches your control unit.
Software on the SD card is locked for
another control unit with another serial
number/ bar code.

Use a SD card with software that
matches your control unit.
The internal copy protection does not
allow access to the microprocessor.
1. Insert the SD card in the machine
again.
2. Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The file 10001341.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.

ERROR CODES

Error codes for welding program package
10645900.bin
Error code
24
Cause and solution
There is no welding programs present
in the control unit

Insert a SD card with software in the
control unit and turn on the machine.
See page 19.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT or use another SD card.
It is only possible to have one file with
welding programs.

Make sure that there is only one file
with the number 10645900.bin on the
SD card. See page 19.
The welding program package does
not match this control unit.

Use a SD card with software that
matches your control unit.
The welding program package is
locked for another control unit with
another serial number/ bar code.

Your software package is copy
protected and cannot be used for a
control unit without the correct license.
The control unit is defective

Contact MIGATRONIC Service.
The file 10645900.bin is not present on
the SD card.

See page 19.
The file 10645900.bin has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
The Sigma folder with files are not
present at the card or are saved
incorrectly.
1. Make a folder
MIGA_SW / SIGMA as described on
page 19 and save the files in the
folder.
2. Exchange the SD card
The internal memory is to small

Welding program package cannot be
loaded