Error Codes - Migatronic RALLY MIG 161i Manuel D'instruction

One of the below mentioned error codes will be displayed if an error occurs during software update.
Error codes for control software 10001901.cry
Error code Cause and solution
There is no software present in the
control unit.

Insert a SD card with software in the
control unit and turn on the machine.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT and place the files down
on the card or use another SD card.
SD card contains no software.

See page 15.
SD card has more files of the same
name.

See page 15.
The control unit has tried to read more
data than is accessible in the memory.
1. Insert the SD card again.
2. Replace the SD card.
3. Contact MIGATRONIC Service.
Software on the SD card is locked for
another type of control unit.

Use a SD card with software that
matches your control unit.
Software on the SD card is locked for
another control unit with another serial
number/ bar code.

Use a SD card with software that
matches your control unit.
The internal copy protection does not
allow access to the microprocessor.
1. Insert the SD card in the machine
again.
2. Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The file has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.

ERROR CODES

Error codes for welding program package
10647001.bin
Error code
17
Cause and solution
There is no welding programs
present in the control unit

Insert a SD card with software in the
control unit and turn on the machine.
See page 15.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT or use another SD card.
It is only possible to have one file
with welding programs.

Make sure that there is only one file
with the number 106470xx.bin on
the SD card. See page 15.
The welding program package does
not match this control unit.

Use a SD card with software that
matches your control unit.
The welding program package is
locked for another control unit with
another serial number/ bar code.

Your software package is copy
protected and cannot be used for a
control unit without the correct
license.
The control unit is defective

Contact MIGATRONIC Service.
The file 106470xx.bin is not present
on the SD card.

See page 15.
The file has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
The MY folder with files are not
present at the card or are saved
incorrectly.
1. Make a folder MIGA_SW / MY as
described on page 15 and save the
files in the folder.
2. Exchange the SD card