Error Code - Migatronic AUTOMIG2 183i Manuel D'instruction

One of the below mentioned error codes will be displayed if an error occurs during software update.
Error codes for control software
10001621.cry/10001641.cry/10001661.cry

Error code

Cause and solution
There is no software present in the control
unit.

Insert a SD card with software in the
control unit and turn on the machine.
SD card is not formatted.

The SD card must be formatted in a PC
as FAT and place the files down on the
card or use another SD card.
SD card contains no software.

See page 18.
SD card has more files of the same name.

See page 18.
The control unit has tried to read more
data than is accessible in the memory.
1. Insert the SD card again.
2. Replace the SD card.
3. Contact MIGATRONIC Service.
Software on the SD card is locked for
another type of control unit.

Use a SD card with software that matches
your control unit.
Software on the SD card is locked for
another control unit with another serial
number/ bar code.

Use a SD card with software that matches
your control unit.
The internal copy protection does not
allow access to the microprocessor.
1. Insert the SD card in the machine again.
2. Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The memory circuit is defective in the
control unit.

Contact MIGATRONIC Service.
The file has an error.
1. Insert the SD card in the machine again.
2. Exchange the SD card.
CAN communication error

Check intermediary cable/plug
Current sensor error
1. Check the current sensor
2. Contact MIGATRONIC service
Probe voltage
1. Check if welding wire is sticking in the
weld pool
2. Contact MIGATRONIC service
Phase/voltage error
1. Check all three phases
2. Check for under-voltage
3. Contact MIGATRONIC service
All manuals and user guides at all-guides.com
ERROR CODES
Error codes for welding program package
10646201.bin
Error code
22
Cause and solution
There is no welding programs present
in the control unit

Insert a SD card with software in the
control unit and turn on the machine.
See page 18.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT or use another SD card.
It is only possible to have one file with
welding programs.

Make sure that there is only one file
with the number 106462xx.bin on the
SD card. See page 18.
The welding program package does
not match this control unit.

Use a SD card with software that
matches your control unit.
The welding program package is
locked for another control unit with
another serial number/ bar code.

Your software package is copy
protected and cannot be used for a
control unit without the correct license.
The control unit is defective

Contact MIGATRONIC Service.
The file 106462xx.bin is not present on
the SD card.

See page 18.
The file has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
The Omega folder with files are not
present at the card or are saved
incorrectly.
1. Make a folder MIGA_SW / OMEGA
as described on page 18 and save the
files in the folder.
2. Exchange the SD card