Télécharger Imprimer la page

protech Promax 4WD Instructions De Montage page 2

Publicité

Engine set -up / Afstellen van de motor
Einstellungen des Motors / Réglage moteur
• Check the ENGINE SET-UP manual to start
and break in the engine
• Lees aandachtig de handleiding AFSTEL-
LEN MOTOR voor het inlopen en roderen
van de motor
• Lesen Sie gründlich die Anleitung EIN-
STELLEN DES MOTORS für das einlaufen
und rodieren vom Motor
• Consultez le manuel REGLAGE DU MOTEUR
pour démarrer et rôder votre moteur
SAFETY PRECAUTIONS
This radio-controlled car is not a toy. Always drive your car with a sense of responsibility.
Read the instructions before use. Never drive your car in public areas or playgrounds.
Never drive on public roads as this can cause accidents. Always keep the environment in mind. Don't drive the car in places where the noice can be
disturbing. Never drive your car in the neighbourhood of heat sources or fl ames.
Check whether there is no one driving another car on the same frequency. This can result to interferences or complete incontrolability of the car. Only
use special model car fuel. Never use other fuels that are explosive or fi re hazardous. A wrong use of the fuel can cause serious injuries or damages.
Only the user is responsible for the use of these products. Protech assumes no liability for the use of this model car.
BEFORE DRIVING CHECKS
Your Pro Max is 90% ready built but we advice to check the following points before driving.
1. Check that all nuts and bolts, screws are tight.
2. Check that the batteries in the transmitter and the car are fully charged.
3. Adjust steering rod and trim to make the car drive straight when the stick is in the middle.
4. Adjust the throttle push rod so that the carburetor is open about 1-2mm when the throttle stick is in the neutral position.
5. Always drive with an air-fi lter. Driving without air-fi lter will cause serious damage to your engine.
6. Check wether the silicone fuel tubing is not split or damaged.
7. Put a little oil on all moving parts i.e.: ball bearings, bushings and ball links.
Before driving the engine needs to be broken in.The fi rst test drives are always done with a certain precaution and driven slowly.
HEAT, FIRE AND FUEL
The engine and muffl er become very hot during the use of the car and can cause severe burns. Never touch the rotating parts. They can cause serious
injuries as they have a high RPM. Only use the fuel in open air and keep out of reach of children or heat sources. Never fi ll the fuel tank when the start
battery is attached to the motor. The fuel is toxic, avoid therefore all contact with skin or eyes.
MAINTENANCE
Let the engine and muffl er cool down before doing the maintenance of the car. Never leave fuel in the fuel tank. It is very important to keep the air fi lter
clean. Use air fi lter oil (item N° LX906) on the air fi lter to avoid sand getting in the engine.
ASSEMBLY
1. Tighten all screws and use nut and stud locker to secure all screws that make metal/metal contact.
2. Check all screws again after the fi rst hour of driving. Check whether the differential is well lubricated.
3. Before driving, make sure that all bushings of wheels and transmission are well lubricated.
4. Don't forget to glue the tyres onto the rims with CA glue.
5. Check on a regulary basis the oil level in the shock absorbers.
- 2

Publicité

loading