Test Device Slot; Usb Port; Operation; General - BD Veritor Plus Instructions D'utilisation

Masquer les pouces Voir aussi pour Veritor Plus:

Table des Matières

Les langues disponibles

3.1.4

Test Device Slot

The test device slot is located on the right side of the BD Veritor Plus Analyzer (see arrow in figure below). Test devices are inserted by

aligning the insertion arrow on the device with the insertion arrow on the Analyzer. A distinctive "click" will be noted when the test device is

properly engaged in the Analyzer.

3.1.5

The BD Veritor Plus Analyzer includes a USB On-The-Go port which is used for three applications:

•

Analyzer Update: the BD Veritor Plus Analyzer can be updated, using a USB flash drive that is provided by BD, to add capability to

read additional BD Veritor assays and to add new features. Instructions to perform these updates are provided with the USB flash

drive when such updates are available.

•

Printing: The optional printer is connected to the BD Veritor Plus Analyzers via this port. See section 2.4 for instructions.

•

Data Download: BD Veritor Plus Analyzers that are equipped with a BD Veritor InfoScan Module can be unlocked to enable secure

transfer of the test record to a computer via this port. See section 4.8 for instructions.

•

Data Transmission: BD Veritor Plus Analyzers that are equipped with the BD Veritor Plus Connect accessory can transmit test results

to a facility LIS over a secure connection via this port.

The BD Veritor Plus Analyzer can be externally powered only from the coaxial power port on the rear of the instrument.

4.1

Section 4.2 provides instructions for routine operation of the BD Veritor Plus Analyzer using the Analyze Now operational mode. In this

mode, the test device is prepared and developed outside of the Analyzer, then inserted to perform the final read. Section 4.3 provides

instructions for routine operation of the BD Veritor Plus Analyzer using the Walk Away operational mode. In this mode, the test device is

prepared outside the Analyzer but allowed to develop inside the Analyzer. The Analyzer initiates the final read at the appropriate time. Both

sections include instructions for operation with or without the BD Veritor InfoScan module installed. Sections 4.4 and 4.5 describe the

Quality Control (QC) test procedure in Analyze Now and Walk Away mode, respectively.

4.2

Using the BD Veritor Plus Analyzer – Analyze Now Operation

The BD Veritor Plus Analyzer is intended for use with BD Veritor Test Devices. Specific instructions for performing a BD Veritor Test can be

found in the package insert included with each test kit. After following those instructions the procedure for interpreting a test result with the

BD Veritor Plus Analyzer using Analyze Now operation is as follows:

Place the BD Veritor Plus Analyzer on a flat, dry, stable surface.

Ensure that the BD Veritor Plus Analyzer is not in direct sunlight or exposed to a bright light.

Check the BD Veritor Plus Analyzer for an inserted device. If a device is present, remove it from the Analyzer.

NOTE

The Analyzer cannot be powered through its USB port.

Table des Matières

Table des Matières