Hürner CNC ECO 200 Manuel Utilisateur page 35

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
All screens of the Configuration Menu work in the same manner: use
the ñ and ò cursor keys to select a displayed configuration option. The
option can then be set to ON or OFF using the ð cursor key. The –M–
displayed at some configuration options indicates that a further screen
for that option can be accessed by pressing the MENU key.
When you press the START/SET key, the displayed settings/
valeus are saved to memory and applied. Press the STOP/
RESET key to quit the currently displayed configuration screen
Important
without saving any modifications you may have made.
The "Sensor Parameters" and "Machine Data" menu options enable
check and maintenance steps that are relevant only to technical service.
They are therefore protected by a second access code and will not be
addressed in this User's Manual.
The "Settings" sub-menu allows the definition of settings related to
the machine itself and its operation during the welding process. In
the "Report Generation" sub-menu, the design of the welding reports
can be defined: which welding and traceability data to record, which
kind of data logging.
The alphanumeric keypad is designed and works like the
keypad of a common mobile phone. If an input is numerical,
the keypress generates the number found on the respective
Info
key. For an alphanumeric input, all characters found on a key
can be generated by pressing that key repeatedly in a row.
As soon as the desired character can be read on the screen,
wait a little longer until you press the next key to use the
displayed character.
In the "Settings" sub-menu of the Configuration Menu, the following
parameters can be set:
Menu Item Setting
Automode ON / OFF
Memory Control ON / OFF
Ambient ON / OFF
Temperature
Manual Input ON / OFF
Automatic Heating ON / OFF
Element
Version February 2018
Description / Possible Data
if ON: if a bead build-up time was previously saved to memory
for the component parameters applicable to the current
welding (see also Sect. 4.5.5), the machine terminates the bead
build-up stage automatically;
if OFF: the bead build-up stage has to be terminated manually
by pressing the ENTER key.
if ON: when the system memory is full of reports, the system
will be blocked until the reports are printed or downloaded;
if OFF: it works but that the oldest report will be overwritten.
if ON: ambient temperature will be checked when machine is
turned on;
If the outside temperature is below 0°C, no welding process
should be started, or appropriate steps should be taken.
if OFF: no check of ambient temperature.
if ON: it is possible to change the welding parameters manually;
if OFF: manual change of welding parameters is impossible.
if ON: if an automatically removing ("jumping") heating
element is used, the system will remove it automatically from
in-between the components during change-over;
if OFF: no automatic removal is controlled by the system even
when an automatically removing heating element is used; the
welder will have to remove it manually at change-over.
HÜRNER CNC ECO 200 User's Manual
13
EN