Printing Label Tags; Displaying Characteristics Of The Welding System; Using Viewweld To Manage Logged Welding Reports And Print Tags - Hürner CNC ECO 200 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
welding by pressing the START/SET key. Pressure to the hydraulic lines
will then be shut off.
Note in general that pursuant to DVS 2207-1 or other inter-
national standards, the cooling time has to be observed and
waited out for its entire length.
A reduction of the cooling time of up to 50%, i.e., joining
Info
pressure release and removal of the welded part from the
welding system, is allowed in the following conditions:
• the welding is done in workshop conditions
• the removal from the welding equipment and the temporary
storage are causing only slight loads to the joint
• it concerns components with a wall thickness of ≥ 15 mm.
Under the welder's responsibility, the cooling time can be
reduced and the welding operation ended early, by pressing
the START/SET key if at least half of the cooling time is over.
A welding operation with reduced-duration cooling time is
identified in the welding report by the indicator -HC- ..
Report data (sample)
Material /
Welding Mode
Diameter
Wall Thickness
SDR Value
Angle

4.5.10 Printing Label Tags

If the optional tag printer is connected to the USB port, tags used to
label the new joint can be printed from Display 25 after the welding.
To do so, press the START/SET key, and printing starts. The number of
tags is defined in the appropriate setting of the Configuration Menu,
under "Settings." The screen indicates the end of printing. If printing
is impossible, the appropriate error message shows on the screen.
4.6

Displaying Characteristics of the Welding System

The key technical information on the welding system itself is displayed
by pressing the ð key at the "Next Welding" screen (Display 4). They
are the software version, the serial number of the system, and the
number of currently available, unused reports. To quit this screen,
press the STOP/RESET key.
4.7 Using ViewWeld to Manage Logged Welding Reports and
Print Tags
The ViewWeld feature offers viewing an abstracted version of the
welding reports recorded during the welding processes and printing
it as a label tag to be affixed to the joint on the optionally avail-
able tag printer. The ViewWeld abstract shows the report number,
the date and time of the welding and the welding parameters along
with an evaluation of the quality of the joint/welding operation (see
Display 27), where the first displayed abstract is that of the last per-
formed welding operation.
To call the ViewWeld abstract of a welding report, press the ñ key
in the Next Welding screen (see Display 4). Browsing through the
saved welding reports is then possible by pressing the  or ð cursor
Version February 2018
PE 100
[mm] 1200
[mm] 109.1
SDR 11.0
[°] 0
HÜRNER CNC ECO 200 User's Manual
-C-HC-
WELDING ABORTED
Error Build-up Pres.
229°C
00128 22.08.14 16:44
PE100
SDR11.0 / 28.6mm
Welding OK
ACT. 1.5bar
Display 26
315mm
Display 27
19
EN