System Start; Four-Speed Gear System; Colour Sensor - Siku RACING 6810 GT Challenge Mode D'emploi

GB

5. System start

1. Switch the model on by moving the switch on the bot-
tom of the vehicle to the
lighting blinks when it is ready to establish connection.
2. Switch on the remote control module by pressing the
button.
3. The connection between the model and remote con-
trol module is established. This process can take up to
five (5) seconds.
4. The connection between the remote control and ve-
hicle has been established once the headlight, rear
light, and the control light on the hand-held trans-
mitter shine continuously. The model is saved in the
remote control module and ready for operation and
can only be controlled by this module.
5. Now the fun can begin.
PLEASE NOTE: By pressing the button
mote control module, the connection between the re-
mote control module and the model is terminated. This
deletes the model from the internal memory. The estab-
lishment of a connection described above and begin-
ning with step one has to be carried out again for the
next system start. In order to prevent the models from
starting up unexpectedly, you should remove the bat-
teries (charged / discharged) from the models after use.
12
The radio technology
used in these models is
equipped with automatic
connection establishment.
The radio control module
and the models connect
automatically and are dis-
ruption-free in relation to
other – and
SIKUCONTROL32 mod-
els. To start the models
for the first time, please
observe the following se-
quence:
"ON" position. The vehicle
on the re-

6. Four-speed gear system

The gear system has four forward gears which enable
different speeds. Each time the vehicle is restarted, it
automatically switches to 2
gears with the button and
thereby adjust your desired speed. To use reverse gear,
you must move the accelerator lever on the remote con-
trol away from you.

7. Colour sensor

Switching on the colour sensor
The colour sensor can be activated during use of the
vehicle. For this purpose, please press
control module. The sensor's readiness for operation
is recognisable from the continuous illumination of the
light-emitting diode (LED), which is positioned directly in
front of the sensor.
Calibrating the colour sensor
If the colour sensor of the model does not react to cor-
responding colour tones, it is possible to calibrated once
per use on the grey track surface as follows:
1. Simultaneously press the buttons
colour sensor switched on (LED illuminates). The light-
ing of the vehicle now blinks alternating between
front and rear.
2. Centre the vehicle on the grey surface of the track
and press the buttons
3 Once the lighting stops blinking the vehicle has been
recalibrated and can be used as normal again.
Attention! It is only possible to calibrate the vehicle
once per use. If it does not function faultlessly, switch
the vehicle completely off (On / Off switch) and repeat
the process.
gear. You can select the
nd
on the transmitter and
on the remote
and with the
and simultaneously again.