Operating Keys Of The Hpg 3000; Connecting Pressure Switch To Hpg 3000 - HYDAC ELECTRONIC HPG 3000-000 Notice D'utilisation

HPG 3000

5 Operating keys of the HPG 3000

HYDAC
PSI bar
SP1
mode
Tasten zur Einstellung der
Keys for adjusting switching output
settings and for scrolling through the
Schaltpunkte, Rückschaltpunkte
menu
und Zusatzfunktionen

6 Connecting pressure switch to HPG 3000

Use the connection cable ZBE 30-02 which is supplied with the unit to connect the
HPG 3000 to the pressure switch.
When the "mode" key is pressed, the data from the pressure switch is transferred to the
programming unit.
This is confirmed by the message "rd" (receive data) in the display.
Before being able to read the data from the sensor, the data transfer method must
be set up in the Basic Menu, depending on whether it is a electronic pressure switch
EDS 4000 ["4000"] or EDS 800-L [„ 800"] (see chap. 7 Basic Menu).
If no pressure switch with programming input is connected, the error
message "Er.21" will appear in the display when you try to transfer data.
This message must to be acknowledged by pressing the mode key.
Er.21 = missing connection or communication fault
(e.g. pressure switch not connected)
Status: 11.09.2015
Display of the
Anzeige der
pressure unit of
Druckeinheit
measurement
4-stellige
4 digit
digital display
Digitalanzeige
SP2
3s
HYDAC ELECTRONIC GMBH
After switching on the supply voltage the
message "HPG" appears in the display for
about 3 seconds, followed by "LoAd".
5
E
Part No.: 669716