Hpg 3000 Program Flow Chart; Eds 4000 - HYDAC ELECTRONIC HPG 3000-000 Notice D'utilisation

HPG 3000

10 HPG 3000 program flow chart

After connecting the HPG 3000 to the pressure switch, switch on the voltage supply.
The message "HPG" appears.
Afterwards you can navigate through the relevant menus, as shown.
If no key is pressed for 5 s, the display jumps to the next higher menu. In
so doing changed values are accepted.

10.1 EDS 4000

bar
Status: 11.09.2015
= Importing the values into the programming device;
HPG memorises the settings of the most recently connected
EDS 4000
= Repair: only proposed if a data error has occurred in the EDS 4000
and if the part number does not correspond with the check number
of the connected EDS 4000 with the stored data.
Repair can be carried out by pressing „mode or skipped by pressing
or
◄ ►
= Overwriting the values in the pressure switch is only possible
if the part number of the connected EDS 4000 is the same as
in „LoAd".
HYDAC ELECTRONIC GMBH
13
E
Part No.: 669716