Handling Cards - Renkforce AR-2808 Notice D'emploi

1. Scan the master card 5x to activate program group 5.
The blue status LED flashes during programming and the 5 power indicator LEDs lights
up. After approx. 2 seconds, 2 beeps sound for confirmation and power indicator LEDs
1 and 2 flash to indicate the 2 available options.
2. Press the doorbell key to select option 2.
Power indicator LED 2 lights up. After approx. 2 seconds, 2 beeps sound for confirmation
and the 5 power indicator LEDs flash.
3. Press the doorbell key again to select one of 5 memory groups for the super access
card you wish to erase.
The LED of the selected memory group lights up. After approx. 2 seconds, 2 beeps
sound to confirm the selection.
4. Press the doorbell key again to erase the super access card.
2 beeps sound to confirm the card has been successfully erased.
Repeat steps 3 and 4 to erase additional super access cards if necessary.
5. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
e) Handling cards
1. Scan access card to open the door.
• Scan the access card 1x.
• 2 beeps sound for confirmation when a valid access card is successfully scanned.
The LED of the corresponding memory group lights up while the door lock pulse
activates.
• 5 beeps sound when an invalid card is recognized.
2. Scan super access card to open the door.
• Scan the super access card 2x within 3 seconds.
• 2 beeps sound for confirmation when a valid super access card is successfully
scanned. The LED of the corresponding memory group lights up while the door lock
pulse activates.
57