Renkforce AR-2808 Notice D'emploi page 50

1. Scan the master card 2x to activate program group 2 (erasing access cards).
The blue status LED flashes during programming and the 2 power indicator LEDs lights
up. After approx. 2 seconds, 2 beeps sound for confirmation and power indicator LEDs
1, 2 and 3 flash to indicate the 3 available erase options.
2. Press the doorbell key to select Erase option 2.
Power indicator LED 2 lights up. After approx. 2 seconds, 2 beeps sound to confirm the
selection.
3. Scan the access card, which has been registered before the lost card.
For example, if Card No. 4 has been lost, scan Card No. 3. Card No 4 is erased. Repeat
these steps to erase any additional lost cards. Repeated scanning of Card No. 3 will
erase Cards No. 5, 6, 7 etc. Card No. 5 will follow Card No. 3 in the memory group once
the lost Card No. 4 has been erased. For each card erased, the memory group LED lights
up for approx. 1 second. 2 beeps sound for confirmation.
If Card No. 1 is lost, use the super access card, as there is no previous card
in the system. A super access card must be created for each memory
group. See chapter Creating super access cards.
4. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
50