Renkforce AR-2808 Notice D'emploi page 53

2. Press the doorbell key to select output mode 1.
Power indicator LED 1 lights up. After approx. 2 seconds, 2 beeps sound to confirm the
selection.
3. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
Output mode 2 - Set period from 1 to 60 seconds (door lock pulse)
1. Scan the master card 3x to
activate program group 3
3. Period setting
start
1. Scan the master card 3x to activate program group 3.
The blue status LED flashes during programming and the 3 power indicator LEDs lights
up. After approx. 2 seconds, 2 beeps sound for confirmation and power indicator LEDs
1 and 2 flash to indicate the 2 available output modes.
2. Press the doorbell key to select output mode 2.
Power indicator LED 2 lights up. After approx. 2 seconds, 2 beeps sound to confirm the
selection.
3. Press the doorbell key again to start the period setting.
The period is indicated by 1 beep per second. The 5 power indicator LEDs function here
as an indicator of time from 1 to 5 seconds on the first pass, 6 to 10 seconds on the
second past, etc., up to 60 seconds.
4. Press the doorbell key again to stop the period setting once the desired time is
reached.
2 beeps sound to confirm the setting and the LED stops at the corresponding position.
Repeat steps 3 and 4 to adjust the period setting.
4. Period setting
stop
2. Select output
mode 2
5. Exit programming
mode
53