Renkforce AR-2808 Notice D'emploi page 56

2. Press the doorbell key to select option 1.
Power indicator LED 1 lights up. After approx. 2 seconds, 2 beeps sound for confirmation
and the 5 power indicator LEDs flash.
3. Press the doorbell key again to select one of 5 memory groups for the super access
card you wish to register.
The LED of the selected memory group lights up. After approx. 2 seconds, 2 beeps
sound to confirm the selection.
4. Scan a new access card 1x to create it as a super access card.
2 beeps sound to confirm the card has been successfully registered. Mark the super
access card along with its memory group allocation.
The new super access card replaces any old one already present in the
memory group.
Repeat steps 3 and 4 to register additional super access cards in other
memory groups (one super access card per memory group/max. 5 super
access cards).
5. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
Option 2 - Erasing a super access card
You can erase a super access card from the system should one be lost.
1. Scan the master card 5x to
activate program group 5
3. Select memory
group 1 - 5
56
2. Select
option 2
4. Erasing a
super access
card
5. Exit programming
mode