Renkforce AR-2808 Notice D'emploi page 52

The LED of the selected memory group lights up. After approx. 2 seconds, 2 beeps
sound to confirm the selection.
4. Press the doorbell key again to erase the memory group.
The LED of the selected memory group flashes while the group is being erased. 2 beeps
sound to confirm the group has been erased.
Repeat steps 3 and 4 to erase additional memory groups.
5. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
Once a memory group has been erased, it is necessary to re-register all
user cards in this memory group. Follow the instructions under Program
group 1 - Registering access cards.
Program group 3 - Output mode for the electronic door lock
Operation for the door lock can be set to Start/Stop or to a period of 1 to 60 seconds.
The default setting is 2 seconds.
Output mode 1 - Start/Stop
1. Scan the master card 3x to
activate program group 3
3. Exit programming
mode
1. Scan the master card 3x to activate program group 3.
The blue status LED flashes during programming and the 3 power indicator LEDs lights
up. After approx. 2 seconds, 2 beeps sound for confirmation and power indicator LEDs
1 and 2 flash to indicate the 2 available output modes.
52
2. Select output
mode 1