Renkforce AR-2808 Notice D'emploi page 48

1. Scan the master card 1x to activate program group 1 (registering access cards).
The blue status LED flashes during programming and the LED for memory group 1 lights
up. After approx. 2 seconds, 2 beeps sound for confirmation and the 5 LEDs flash to
indicate that 5 memory groups are available.
2. Press the doorbell key to select one of 5 memory groups for the access cards.
The LED of the selected memory group lights up to show that the memory group is
available for the registration of additional access cards. After approx. 2 seconds, 2
beeps sound to confirm the selection. The corresponding LED flashes when the
memory group is full.
3. Registering access cards.
Scan and save access cards to the desired memory group one at a time. 2 beeps sound
after each registration for confirmation.
4. Scan the master card 1x to exit programming mode.
2 beeps sound. This confirms that the product is in normal operation mode.
Press the doorbell key to select additional memory groups and proceed
with steps 2 - 3 before exiting programming mode.
Each access card may be registered in the system only once. Repeated
registration in various memory groups is not possible. When attempted, a
long beep sounds to indicate the card cannot be accepted.
Program group 2 - Erasing access cards
Access cards can be erased from the system when they are no longer in use or have
been lost. There are 3 different erase options available:
Erase option 1 - Erase an unused card
Erase option 2 - Erase a lost card
Erase option 3 - Erase a memory group
48