U14 How To Activate The "Follow Me" Function; U15 Alarm Indication; U16 How To Activate An Additional Relay Art. 1256; U17 How To Call A Secondary Switchboard From A Main Switchboard - Comelit 1998NA Manuel Technique

U14 How to activate the "Follow Me" function

This function can be used to divert calls for the
switchboard to local or remote telephones.
To activate this function, press and hold the DAY/
NIGHT key for at least 3 sec., until the display
shows:
FOLLOW ME
ACTIVE
To disable it, repeat the procedure so that the initial
screen appears on the display:
AT (_ _)
D
WED 12/03/20
Once a call has been made, the switchboard will
ring until the remote device begins communicating;
the call can be answered from the switchboard by
cancelling the "Follow me" function.
CAUTION!
To use this function, telephone switchboard Art.
2906 and interface Art. 2912 must be fitted.
Contact your usual installer.
This function can only be activated for the
switchboard set as secondary (see "C8.3 Type of
switchboard").

U15 Alarm indication

The switchboard can
transmitted by internal units in any operating status
(call or conversation).
When the switchboard receives an alarm:
- an audible alarm sounds. The signal may be
silenced by pressing any of the buttons on the
switchboard.
- the alarm signal for the first user that activated the
alarm appears on the display:
ALARM
USER
the signal disappears when the internal unit answers
the switchboard call (to make the call, press
when the switchboard operator forces a deletion
process using the CANC key.
If several alarm situations occur simultaneously, an
alarm code is created using the same methods as
described in the section "U6 How to call an internal
unit listed in the call queue", and only the number
of alarms recorded will appear on the display (max.
10).
When a call is received from an external or internal
unit, the switchboard exits alarm status so that the
incoming call can be dealt with correctly. Once the
call has been dealt with, alarm status is restored.
14:40
receive alarm signals
(04)
002
), or

U16 How to activate an additional relay Art. 1256

(e.g. to activate independently using a specific
command: lights, CCTV alarm contacts, vehicle
barriers, entrances without an external unit or
other devices)
Actuators can be activated in standby mode and
during conversation with an external unit.
To activate the actuator:
- press , you will be asked to enter the code
to activate a specific actuator. If there is no code a
generic actuator will be activated;
ACTUATOR
CODE:
- to confirm actuator activation, press
CAUTION!
To use this function, there must be a main
external unit and actuators Art. 1256. Contact
your usual installer.
U17 How to call a secondary switchboard from a
main switchboard
When calling a secondary switchboard, the main
switchboard may use one of the 3 following methods:
• enter the switchboard number (e.g. 005 240) and
press :
USER: 005 240
TO CALL
• scroll through the name directory using the
keys until the name is displayed and press
SWITCHBOARD 005
CODE: 005 240
• press the corresponding speed number (see "I4
Recording speed numbers").
- if the call has taken place correctly:
CALLING
USER 005 240
- if the call has not taken place correctly:
USER 005 240
NOT AVAILABLE
.
:
37