C8.1 Video Mode Configuration; C8.2 Calling Mode - Comelit 1998NA Manuel Technique

C8.1 Video mode configuration

This is disabled by default.
Activating this function will allow you to make a
video call to an internal unit. The monitor called by
the switchboard will switch on, making it possible
to view, for example, the images from the remote
cameras connected to Art. 1259C.
VIDEO mode can be NORMAL or DIRECT.
In NORMAL mode, the internal unit video feed
begins when the handset is lifted, or when the
audio line is activated in receipt of a call from the
switchboard; while in DIRECT mode, on the other
hand, it begins automatically on receipt of a call.
To activate the function:
- press MENU and use the
8-ADVANCED OPTIONS menu, then press 8;
8-ADVANCED
OPTIONS
1-VIDEO MODE
CONFIGURATION
- press 1 to activate or deactivate the function;
SERVICE
ACTIVE
SERVICE
NON ACTIVE
- if the service has been activated, you will be asked
to select one of the 2 modes.
Press 1 for NORMAL MODE or 2 for DIRECT
MODE;
*1-NORMAL MODE
2-DIRECT MODE

C8.2 Calling mode

This function can be used to select the manual
switchboard calling mode, from the 3 options
available:
1- SIMPLEBUS CODE (default), the call is made by
entering the code corresponding to each user.
• If the system is a SIMPLEBUS type, the door-
entry phone user is identified by a Username field
(optional) and a Code field no longer than 3 digits
(between 1 and 240).
EXAMPLE: Username = Smith; Code = 015.
• If using a SIMPLEBUS TOP system, the door-entry
phone user is identified by the Username field
(optional) and a Code field consisting of two parts,
a zone field with up to 3 digits (between 1 and 500)
and a user field which must have 3 digits (between
keys to view the 1 and 249).
EXAMPLE: Userame = Smith; Code = 25 015.
2- INDIRECT CODE , the call is made by entering
the indirect code, which should have a maximum
of 6 digits. This code must be stored in the memory
and associated with the user who has been given
a name (compulsory) and Simplebus (or Simplebus
TOP code).
3- INDIRECT CODE WITHOUT NAME, see previous
mode; the difference is that in this case the name
field is not compulsory. In this mode, FILTER OFF
or FILTER ON will be requested; if activated only
named users will appear on the display; however, if
the filter is deactivated, all users will be displayed.
To activate the function:
- press MENU and use the
the 8-ADVANCED OPTIONS menu, then press
8;
- use
press 2;
- view the selected mode using the
press 1 for the SIMPLEBUS CODE, press 2 for the
INDIRECT CODE, or 3 for the INDIRECT CODE
WITHOUT NAME;
- if choosing 3- DIRECT CODE WITHOUT NAME,
filter activation is required; press 1 to disable or 2to
activate it;
8-ADVANCED
OPTIONS
to view the 2-CALLING MODE menu, then
2-CALLING
MODE
*1-SIMPLEBUS CODE
2-INDIRECT CODE
3-INDIRECT CODE
WITHOUT NAME
*1-FILTER OFF
2-FILTER ON
keys to view
keys, then
45