Maintenance And Cleaning; Handling - VOLTCRAFT B6 Quadro Notice D'emploi

Example for a 3 line LiPo battery:

18. Maintenance and Cleaning

The product does not require any maintenance therefore you should never take it apart.
The product should only be repaired by a specialist or specialist workshop or it may be damaged. Fur-
thermore, the CE approval and the guarantee/warranty will become void.
Clean the product only with a soft, clean, dry and fuzz-free cloth. Do not use cleaning agents as they
may corrode the casing and wear off the labelling.
Dust can be removed using a clean, soft brush and a vacuum cleaner.

19. Handling

• Observe all safety information in these operating instructions! They provide you with
important information about the dangers involved when handling battery chargers and
batteries.
• The product is not a toy and must be kept out of reach of children. Children cannot judge
the dangers involved when handling chargers or batteries.
• Avoid the following unfavourable ambient conditions at the place of installation, during
operation or when transporting:
- Dampness or high humidity
- extreme cold (<0°C) or heat (>+35°C), direct sunlight,
- Dust or flammable gases, fumes or solvents
- strong vibration, hits or blows,
- strong magnetic fields such as those near machines or loudspeakers
• Place the charger on a level, firm surface. It must be large enough so that the battery or
battery pack attached can be safely placed alongside the charger. Maintain a minimum
of 20cm between the charger and battery (and the power supply) to prevent them from
heating each other up.
The battery/battery pack may not be placed on or under the charger!
• When setting up and using the product, make sure that the cable is not folded or
squeezed.
• Never cover the charger and the battery! By preventing heat from escaping, not only will
the battery be destroyed, there is also a risk of fire and explosion!
71