VOLTCRAFT B6 Quadro Notice D'emploi page 66

• Briefly press the button "START/ENTER". The time display then begins to flash. With the buttons "INC"
or "DEC", you can select the time (5 to 60 minutes). Save the setting with the button "START/ENTER";
the voltage then stops blinking.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous setting or return
to the main menu with the button "BATT. TYPE/STOP".)
Here you can set the sensitivity of the delta-U detection of NiMH battery (voltage difference in the delta-U
charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the bat-
tery may not be completely charged.
• Briefly press the button "START/ENTER". The voltage value then begins to flash. With the buttons
"INC" or "DEC", you can set the voltage value (5 to 20mV).
• If you select "Default", the charger uses a pre-specified voltage of 7mV. This setting is recommended.
• Save the setting with the button "START/ENTER"; the voltage then stops blinking.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous setting or
return to the main menu with the button "BATT. TYPE/STOP".)
Here you can set the sensitivity of the delta-U detection of NiCd batteries (voltage difference in the delta-
U charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the bat-
tery may not be completely charged.
• Briefly press the button "START/ENTER". The voltage value then begins to flash.
• With the buttons "INC" or "DEC", you can set the voltage value (5 to 20mV). If you select "Default", the
charger uses a voltage of 12mV. This setting is recommended.
• Save the setting with the button "START/ENTER"; the voltage then stops blinking.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous setting or return
to the main menu with the button "BATT. TYPE/STOP".)
65