Flash Opt Optimisation Programme - Corghi ProLine 650 Manuel D'utilisation

illuminates
- Press the
"Motorcycle ALU" programme (the corre-
sponding balancing planes are highlighted
on the rim shown on the control panel).
- Proceed as described previously for the
"Motorcycle Dynamic" programme.
- Use the 12 o'clock position as reference
for applying the adhesive weight.
best results can be achieved if the adhesive
weights are positioned with the outer edge
flush with the rim edge.
Split Weight programme (available
only with motorcycle programmes)
Some rims have spokes so wide that it is
not possible to place adhesive weights
next to them; a programme which divides
the counterweights into two parts has been
introduced to solve this problem.
In this case, when the centred position is
reached and it becomes obvious that the
balancing weight will have to be applied
in line with a spoke, proceed as follows:
- remain in the centred position;
- press ;
- use the
the width of the spoke:
• 1 = small
• 2 = medium
• 3 = large
• OFF = deactivates the programme
- confirm with the
- apply two new counterweights in the
positions indicated.
68
.
button twice to select
keys to select
key;
In "MOTORCYCLE ALU" and "dynamic"
modes it is possible to divide the balanc-
ing weights over both sides of the wheel
to be balanced.
FLASH OPT
OPTIMISATION
PROGRAMME
This procedure minimises any vibration
still present on the vehicle while running
even after accurate balancing, thus mini-
mising the rim-tyre coupling run-out.
based on our experiences, the programme
can be recalled every time it is convenient
to minimise the running noise produced by
the vibrations mentioned above.
The calculations performed by this pro-
gramme are based on the unbalance values
measured during the last spin performed
which must therefore refer to the wheel
being serviced.
Proceed as follows to recall this pro-
gramme:
- Press the
the LED corresponding to the OPT pro-
gramme illuminates.
- Press the
selection.
Once the selection has been made, the
machine will indicate whether it is conveni-
ent to proceed with the programme. To do
this the machine will flash the following
message:
• "YES OPT" if it is worth executing the
programme;
• "NO OPT" if it is not.
Press the
gramme and return to the DYN environ-
ment.
User manual ProLine 650
and keys until
key to confirm the
key to exit the pro-