Corghi ProLine 650 Manuel D'utilisation page 48

position indicated in Fig. 6.
Fastening machine to floor
(fig.6a)
Should it be necessary to fasten the ma-
chine to the floor, proceed as follows:
- undo the three M8x60 hex head screws
fastening the machine to the pallet;
- remove the plastic washers between
the casing and the three L brackets: the-
se brackets will be used to fasten the ma-
chine to the floor;
- refit the brackets on the machine in the
original positions, without tightening the
screws;
- Move the machine into the desired po-
sition, ensuring that sufficient clear space
around the machine as indicated in fig.5a;
- Mark the positions for the holes on the
floor;
- drill holes in the positions marked and
insert Fischer M8 anchor bolts in the ho-
les;
- Secure the machine to the floor by fa-
stening the L brackets to the Fischer an-
chor bolts using the relative screws and
washers (fig.6);
- Tighten the three fastener screws to the
casing.
48
6
Main working parts (Fig. 7)
(A) diameter and distance measuring arm
(b) automatic width measuring arm
(C) flange holder
(D) weight tray
(E) wheel support shaft
(F) wheel guard (version with guard)
(G) display panel
(I) Wheel-holder shaft locking brake (op-
tional)
User manual ProLine 650
6a
7