Corghi ProLine 650 Manuel D'utilisation page 64

- Rotate the end of the measuring arm until the weight adhesive strip is in line with the
rim surface.
- Press the button (Fig. 15d) to eject the weight and make it stick to the rim.
- Return the measuring arm to the rest position (Fig. 15e).
- Repeat the operations to apply the second balancing weight.
- Perform a test wheel spin to check the balancing accuracy.
VERSION WITH MANUAL SENSOR
with the wheel in the centred position the machine screen displays the imbalance value:
- Turn the wheel until the central element of the corresponding position indicator lights
up.
- Apply the adhesive weight manually at 12 o'clock in the position in which the relative
plane was measured, using the centre of gravity of the weight itself as reference.
The rim surface must be perfectly clean to make the weight stick efficiently to the rim. If
necessary, clean the surface using suitable cleansing products.
"Shift planes" programme (available only with Alu p programmes)
This function is automatically enabled when an ALU P programme is selected.
It modifies the selected positions for the application of adhesive weights, so as to ensure
perfect balancing of the wheel using commercially available adhesive weights (i.e. mul-
tiples of five grams). The accuracy of the machine is thereby improved, avoiding rounding
off or cutting the weights to be applied to come closer to the actual unbalance values.
The modified positions, where the adhesive weights are to be applied, are identified by
the user according to the information given by the wheel balancer (see the bALANCING
WEIGHT APPLICATION section).
"HIDDEN WEIGHTS" PROGRAMME (available only with the ALU P
This programme divides the outer weight Pe into two weights P1 and P2 located in any
position chosen by the operator.
The only condition is that the two weights and the original outer weight Pe must be within
an angle of 120°, as shown in Fig. 16.
64
programme)
User manual ProLine 650
16