Flap Servo Installation - Horizon Hobby HANGAR 9 Tiger 30cc Manuel D'utilisation

45. Attach the ball end to the servo arm using an M3 x 15 socket
head cap screw, two M3 washers and an M3 locknut.
46. Attach the servo arm to the servo using the hardware
provided with the servo.
47. When mounting the aileron servos arms, they will face toward
the wing tips on each wing panel.
 Installing the aileron servos facing the opposite direction
allows their connection to the receiver using a Y-Harness.
48. When mounting the aileron servos, the servo arms will face
toward the wing tips on each wing panel.
 Installing the aileron servos facing the opposite direction
allows their connection to the receiver using a Y-Harness.
EN
49. Adjust the linkage as necessary to align the aileron with the
fl ap.
50. Once adjusted, tighten the nut to keep the clevis from
vibrating loose. Slide the retainer over the forks of the clevis.

FLAP SERVO INSTALLATION

51. Install the fl ap servos in the wing. The procedure is the same
as the aileron servos. When installing the fl ap servos, the
servo arm on both servos will face toward the left wing tip.
 Installing the flap servos facing the same direction allows
their connection to the receiver using a Y-Harness.
52. Prepare the pushrod for the fl aps. This is the same procedure
as the pushrod for the aileron. When attaching the ball end
to the servo arm, use the hole that is 5/8 in (16mm) from the
center of the servo horn.
53. Attach the fl ap pushrod. These steps are the same as the
aileron pushrod steps.
10
5/8 inch
(16mm)