Remote Slave Flash Mode Settings; Setting The Slave Channel - Metz mecablitz 64 AF-1 digital Mode D'emploi

10.2.1 Remote slave flash mode settings

• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. TTL flash mode).
• Press the displayed mode of operation on
TTL
the touch display as many times as it takes
for the display for selecting the mode of
0.8- 9.0 m
operation to appear.
M-
5,6
35 m
Zoom F
m
EV
• Press the
MODE
touch display and select
STROBO
REMOTE SLAVE
• Press the
SERVO
the touch display.
Remote slave mode is set.
p
q
In addition, the selected slave group (e.g. A)
Gr Ch
REMOTE
and the remote channel (e.g. CH 1) are dis-
SLAVE
A 1
played.
M-
Zoom 24
m
m
sensor buttons on the
REMOTE SLAVE
.
REMOTE SLAVE
s ensor button on

10.2.2 Setting the slave channel

• Press the sensor button on the touch
Gr Ch
REMOTE
SLAVE display for the channel group (e.g.
A 1
Gr A I Ch1
M-
The window for selecting the channel and
Zoom 24
m
group appears.
m
SLAVE
• Press the sensor buttons on the touch
display for the channel
CHANNEL
GROUP
• Press the
touch display and select the desired
channel.
CHANNEL
CHANNEL 1
• Press the selected channel on the touch
CHANNEL 2
display.
CHANNEL 3
p
q
Gr Ch
REMOTE
SLAVE A 2
M-
The setting will take effect immediately.
Zoom 24
m
m
"CH2" appears on the display.
+
).
CHANNEL .
sensor buttons on the
169
k