Remote Slave Flash Mode Settings; Setting The Slave Channel - Metz mecablitz 64 AF-1 digital Mode D'emploi

10.2.1
• Switch on the flash unit with the
TTL
• Press the displayed mode of operation on
0.8- 9.0 m
M-
m
35
Zoom
m
EV
O
MODE
• Press the
REMOTE MASTER
REMOTE SLAVE
SERVO
• Press the
k
p
q
RMT Ch
REMOTE
SLAVE 2 1
M-
Zoom 24 m
Remote slave mode is set.
m
P
In addition, the selected slave group (e.g.
1/1
RMT) and the remote channel (e.g. CH 1) are
displayed.
186

Remote slave flash mode settings

button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. TTL flash mode).
the touch display as many times as it takes
for the display for selecting the mode of
operation to appear.
sensor buttons on the
REMOTE SLAVE
touch display and select
REMOTE SLAVE
s ensor button on
the touch display.
RMT Ch
REMOTE
SLAVE 2 1
M-
Zoom 24 m
m
O
SLAVE
CHANNEL
GROUP
O
CHANNEL
.
CHANNEL 1
CHANNEL 2
CHANNEL 3
p
q
RMT Ch
REMOTE
SLAVE 2 2
M-
Zoom 24
P
1/1
10.2.2

Setting the slave channel

• Press the sensor button on the touch display
RMT I CH1
for the channel group (e.g.
The window for selecting the channel and
group appears.
• Press the sensor buttons on the touch
CHANNEL
display for the channel
• Press the sensor buttons on the
touch display and select the desired
channel.
• Press the selected channel on the touch
display.
The setting will take effect immediately.
"CH2" appears on the display.
).
.